The PVC project department actively responded to the company's call, encouraged everyone to contribute ideas and put forward reasonable suggestions, and achieved good results.

Because the embossing frame of the extruder is manually adjusted, mainly relying on the master's personal experience and feel, the phenomenon of depth and shallow pressure often occurs, which directly affects the surface effect of the edge banding strip. In order to completely solve this problem, the project department organized personnel to change the manual embossing to the automatic embossing of the equipment after repeated analysis and discussion. After improvement, it can be embossed according to the different requirements of customers, with high accuracy and strong stability, and can also automatically adjust the thickness and fix the thickness, which solves the previous experience of relying on the master's personal hand embossing, and replaces the personal feel with digital standardization, and the use effect is good.

In the process of stirring in the batching section, the addition of dioctyl grease has been manual, and the quantity and time control are not in place, which is easy to cause quality hazards and cost waste. In order to stabilize the quality and reduce the labor intensity, the project department organized relevant personnel to make an automatic refueling device after repeated trials and improvements, which replaced manual operation with the help of mechanical force, which not only saved the amount of consumption, but also improved work efficiency.

Small reforms and small reforms create big benefits, and we must have the courage to break the traditional model in our work, continue to innovate, and contribute to the company's leapfrog development.